Paver driveway cost in Daytona Beach (2026 ranges)

Cost by driveway size

The middle column uses $10 to $18 per sq ft, which is where many ordinary residential jobs land once a real base is included. The wider column uses $10 to $30 per sq ft. Tear-out is not in either column.

Small drives sometimes price above the low end because the crew, the saw, and the dumpster do not shrink with the square footage. That shows up in Holly Hill, Daytona Beach Shores, and beach cottages.

Cost by material

What those ranges try to include

• Excavation to the depth the installer specifies.
• A compacted base, often discussed as about 6 to 8 inches for a driveway, over fabric when the sand is loose.
• Bedding sand, pavers, edge restraint, joint sand, and the labor to set them.
• Basic cleanup.

What is often extra

• Removing and hauling an old slab. Angi says to budget demolition and does not publish a single per-square-foot rate we will cite. HomeAdvisor says removing an existing patio can reach $3,700 depending on size and material.
• The apron in the public right of way, and any permit fee.
• Decorative borders, circles, and heavy cutting.
• Drains, root barriers, and moving irrigation.
• Sealing. Many installers leave that for later on purpose.
• Difficult access, including a pool cage or a gate the pallet cannot fit through.

How to read a quote

Ask for square footage, base thickness, fabric, edge type, who pulls a permit, and whether tear-out is included. A price far under the ranges above sometimes means the base is thin. A price far over them can be honest when access is awful or the shape is complicated. The paver driveway page lists questions worth asking on the visit. If you are choosing between pavers and a new slab, use pavers vs concrete.

Which published band to use

Angi's 2026 paver driveway page, updated October 15, 2026, puts a national size table at $10 to $30 per square foot. The same page lists standard driveways at $10 to $18, permeable at $15 to $25, decorative at $18 to $30, and brick at $12 to $22. Labor is $5 to $15 per square foot or $50 to $80 per hour. A 600 square foot driveway on that size table is $6,000 to $18,000. HomeGuide's installed driveway band is also $10 to $30, and it separately says concrete pavers often install at $8 to $15. Use the Angi standard band when you mean an ordinary concrete paver drive, and say so. Do not blend it into a pretend Volusia average.

The old habit of quoting a single $14 to $20 local band is retired on this site. That band was inside the national ranges, but it was not itself a published figure. Last checked November 1, 2026. Demolition stays a separate line. HomeAdvisor says removing an existing patio can reach $3,700 depending on size and material. That ceiling is not a per-square-foot tear-out rate.

1. Write the square footage both bidders used. A 20 by 30 foot two-car drive is about 600 square feet before the flare.
2. Ask whether the apron, the permit fee, and haul-away are inside the per-foot number.
3. Match the material to a published band: standard, permeable, decorative, or brick.
4. Open the calculator and keep the printout with the quotes.
5. If the drive touches a city street, open the permit guide for that city before you accept a price that ignores it.